Learn some tips that can help you best maintain and repair your own plumbing. You can figure out everything you need to not fall for unnecessary equipment and expenses and how to save money by doing it all yourself. It’s not so scary once you know the basics of plumbing.
Swithc of the master circuit breaker
You need to winter-proof your house. You have to make sure you switch of the master circuit breaker or the shut-off valve before you leave your house. Since one small hole or congested water can quickly freeze and cause pipes to break and expand, you need to drain and open all outdoor and household water lines.
At least once a year remove the faucet aerator and clean the screens. This helps it properly function. The function of a faucet aerator is to allow for an even flow of water and to conserve water. Be sure to clean out the aerator and you’ll notice a these things working.
Install screen traps or drain
Install screen traps or drain covers on all of your sinks and tub drains. Most home plumbing calls are about clogged pipes. These can be caused by debris, especially hair, washing down the drains. Putting in a trap means that you can clean this debris off before it ends up in the pipes.
If you live in a home using well water and your bathtubs have stains pink and orange in color, this is likely a result of iron levels in the well water. A water softener is the easiest way to solve hard water problems relating to rust, but you can also consult a plumber if you are unsure.
Replace the damaged pipe
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
To avoid sediment buildup, drain gallons of water from your water heater to flush any corrosion. This will help your heater to run more efficiently therefore saving you regular energy costs. Make sure to read your heater’s instructions before attempting this, and do this periodically to make sure that your heater is running as well as it can.
If your plumbing is making strange noises you may have lost something called your “air cushion”. To turn this back on, you’re going to need to turn off your main water supply. Run all faucets in your house and then turn back on your main water supply. This should make everything sound better again.
As you can see, maintaining and repairing your own plumbing isn’t as difficult as it may appear at first glance. It just requires doing research, getting documents in order and asking a lot of questions. The work will pay off once you see how it can help save you money.